 |
1. Product Name: Self-Propelled Conveyor-Belt Loader
2. Product Model: TY-XC80
3. Product Introduction:
TY-XC80 self-propelled conveyor-belt loader is a new luggage transporter designed and manufactured by Jiangsu Tianyi Aviation Industy Co., Ltd. Its chassis is self-made. The product is advanced and concise in product design, safe, reliable, reasonable in structural design, safe and convenient in operation, advanced in process, beautiful in appearance, highly reliable and easy to maintain. It can provide safe and efficient luggage conveying operation for all aircraft types.
Excellent Features:
High loading capacity of front axle (3 tons), remarkable grade-ability, superior low-speed stability (when interfacing with an aircraft).
4. Product Standard:
IATA AHM 925 Functional Description of Power-Driven Conveyor Belt Loader IATA AHM 913 Basic Safety Requirements for Airport Ground Support Equipment IATA AHM 910 Basic Safety Requirements for Airport Ground Support Equipment
5. Major Performance And Technical Parameters
| Height Range of Convener Belt s Front End (mm) | 1200-4325 |
| Height Range of Conveyor Belts Rear End (mm) | 525-1670 |
| Width of Conveyor Belt (mm) | 700 |
| Maximum Uniform Load of Conveyor Belt (kg/m) | 135 |
| Maximum Mass of Single Cargo (kg) | 400 |
| Maximum Inclination of Conveyor Belt | 29° |
| Conveying Speed of Conveyor Belt (m/s) | 0.25-0.5 m/s |
| Maximum Travel Speed (km/h) | 25 |
| Minimum Steady Travel Speed (km/h) | <=3 |
| Wheelbase (mm) | 3000 |
| Minimum Turning Radius (mm) | 6600 |
| Ground Clearance (mm) | 170 |
| Approach Angle | 10° |
| Departure Angle | 15° |
| L*W*H (mm) | 8130*1986*2096 |
| Vehicle Curb Weight (kg) | 3700 |
6. Major Structure And Configuration
TY-XC80 self-propelled conveyor-belt loader primarily consists of body, conveying rack, chassis power drive system, front and rear lifting mechanisms, hydraulic operating system, electrical system and other components.
6.1 Body
Its body is made by welding 4.0 thick high-quality steel plates. The product has the following features: reasonable arrangement, welding as a whole and lower body center of gravity, good stability. An enclosed cab can be installed. It also has wide field of vision.
6.2 Conveying Rack
The conveyor belt support primarily consists of main frame, load-bearing roller, stainless steel slide block, drive roller, driven roller, adjusting roller, and drive motor. The control switch and emergency stop switch are installed respectively at the front and rear ends. The drive motor drives the belt through the drive roller to load up or unload down. The driven roller and the adjusting roller can be used to adjust the belts tension, deflection and deviation. The conveying rack is intended to increase the structural strength. The main frame uses channel beam structure. Buffer rubber blocks are mounted respectively onto the conveying racks front and rear ends.
Made of seamless steel pipe, the load bearing roller is durable. A variable cross-section structure is adopted for drive and driven rollers, thereby eliminating the conveyor belts deviation factors and making it easy to adjust.
100mm high deflector gates are installed respectively at both sides of conveyor belt to prevent luggage from slipping out of the conveying rack; both the left and right gates are movable and below the conveying surface when put down.
