Pallet dolly technical parameters
Dimensions: 3200-3250*1700-1750*1320-1360 ㎜
Table size: 3200-3250*1700-1750*1320X520-560 ㎜
Working platform surface height from the ground: 560 ㎜
Front railing height: 800 ㎜
Rear railing height: 160 mm
Weight: ≥520KG
Minimum load: ≥2000 ㎏
Wheelbase: 2000-2100 mm
Wheel base front wheel: 1200 ㎜; Rear wheel: 1300 ㎜
Maximum driving speed: ≤25km/h
Minimum turning radius: ≤3500mm
Pallet dolly main components description
(1) The frame as a whole is made of [8# channel steel, the upper surface seal is made of ≥3mm pattern steel plate, the outer surface is made of channel steel, the mesh hook is welded in the groove, the diameter of the hook steel is ≥12cm, 8 O-shaped hooks are welded on each side of the fence, and 8 L-shaped hooks are welded in the lower groove, and the welding positions on the left and right sides are consistent. Six V-hooks at the bottom of the back and four O-hooks at the top of the front fence.
(2) The mop is welded from seamless steel pipe with a diameter of 42mm×5mm, and the mop head is made of 25mm round steel. The mop has dual functions of multi-car connection and brake, the mop can automatically brake when put down, and the mop needs to be equipped with a lift; The steering wheel can be rotated 360 degrees, and the diameter of the rotating disk is 500 mm. Brakes Front wheel external round brakes. The joint of the mop should be reinforced with a triangle; The whole length of the mop is 1460mm, and the distance between the outermost side of the mop ring and the most front end of the workbench is 1050mm; Ensure that when two trailers of the same batch and model are connected, the front and rear workshop distance is ≥110cm to avoid contact between the front and rear bodies when the steering is 90 degrees.
(3) Brake and mop integrated brake pads, thickness ≥8mm steel plate, brake with 20mm screw (8.8 level) as adjusting bolts, can be adjusted according to tire wear. Put the mop down and brake the tire.
(4) The forklift hole is made of flat steel ≥50mm. 2 forklift holes on one side.
(5) The tires are 16*5-9 rubber solid tires;
(6) Equipped with rain cloth (≥5m * ≥4m high-density new PE material per square is not less than ≥140g, need strong flexibility, high tear resistance, color is green) and net cover (≥ 4.5m * ≥3.5m, material: Polyester fiber, tensile force: more than or equal to 500 kg, net rope: thick ≥0.5cm, mesh: ≤4cm*≤4cm, net body flat, no water absorption, all around the edge, net rope thickness is ≥0.8cm.
(7) Both sides of the flat car are equipped with their own wheel stop (handle type rubber wheel stop, installed in the middle of the flat car), the wheel stop is welded to the tail of the car with a chain, and is inserted on the tail shelf when not in use, and the height of the wheel stop after being placed is not higher than the plane of the car is not easy to fall off (need to have anti-falling latch).
(8) Install the strip one-dimensional code in the left channel steel groove of the flat car body. Aluminum sheet four point fastening, specific specifications: 120X35X1MM.
(9) Use the most effective automatic rotary closed shot blasting machine to remove rust, and then use high-grade anti-rust primer to prevent rust, and the last two high-grade enamel topcoats (do not fade).
